Brew Styles; Over Ice - Ninja DUALBREW CFP200 Series Owner's Manual

USING THE NINJA® DUALBREW COFFEE MAKER
CONT.
2 Ensure the adapter is in the REMOVE
position before installing. Then place
the adapter over the brew basket and
push down firmly so it is fully seated.
NOTE: Make sure the brew basket is
clean and free of any filters before
inserting the Ninja® Pod Adapter.
3 Slide the Ninja Pod Adapter handle into
the LOCK position.
REMOVE
LOCK
4 Lift the the Ninja Pod Adapter handle
to reveal the pod holder. Place a new
pod in the holder.
12
1-877-646-5288
5 Press the handle down firmly to
pierce the pod, and ensure that it is
completely closed. There will be an
audible click and some resistance
when closing the handle as the needles
puncture the pod.
NOTE: DO NOT remove the top of the
K-Cup Pod.
HIGH-ALTITUDE BREWING: Before
closing the Ninja Pod Adapter handle
to start a brew, Using your fingers,
carefully apply pressure on the K-Cup
Pod until the bottom of the K-Cup
Pod is punctured by the exit needle,
and the pod is fully seated in the pod
holder. This releases excessive gas built
up from the high altitude and prevents
pod blowout.
NOTE: Reusable K-Cup Coffee Filters
are not compatible with the Ninja Pod
Adapter. If using ground coffee, use
the grounds mode with a paper or
permanent filter (sold separately) to
brew a single-serve size.

BREW STYLES

CLASSIC BREW & RICH BREW
1 Use the Multi-Serve dial to select the
brew size. Place the empty vessel
under the brew basket.
NOTE: If making a single cup, lower
the Single-Serve Cup Platform and set
your vessel in the center of it to help
prevent splashing. This applies to all
brew styles.
2 Press the BREW STYLE button to choose
either Classic Brew or Rich Brew.
3 Press the START BREW button on the
dial to start the brew. To cancel the
brew at any time, press the START
BREW button on the dial again or
press the Power button.
NOTE: The brewing cycle will begin,
then pause for a short period before
resuming. This process is used to
evenly saturate the coffee grounds.
This applies to all brew styles.
4 The brewer will beep to signal the brew
has started. The progress bar around the
dial will illuminate to indicate the status
of the brew. When the brew is finished,
the machine will beep again and End will
appear on the display.
NOTE: Rich Brew will use slightly
less water and yield slightly less
brewed coffee than Classic Brew.
See Approximate Brew Volume
chart for additional information.
OVER ICE BREW
1 Fill your desired vessel to the top with
ice cubes and place the vessel below
the brew basket. Use the Multi-Serve
dial to select the brew size.
NOTE: DO NOT add ice to the water
reservoir.
2 Press the BREW STYLE button to
choose Over Ice Brew.
3 Press the START BREW button on the
dial to start the brew. To cancel the
brew at any time, press the START
BREW button on the dial again or
press the Power button.
4 The brewer will beep to signal the brew
has started. The progress bar around
the dial will illuminate to indicate the
status of the brew. When the brew is
finished, the machine will beep again
and End will appear on the display.
NOTE: DO NOT use any glassware
except the provided Ninja glass
carafe, which is safe to use due to its
specialized glass material.
NOTE: Over Ice brew is designed to
produce a concentrated brew into a
vessel filled with ice. It is normal for
some ice in the vessel to melt as the
coffee is brewed, and this will produce
a cold beverage with the ideal strength
and flavor.
ninjakitchen.com
13