Priming Your Ninja Hot & Cold Brew System; High-Altitude Calibration - Ninja Hot & Cold Brew System CP301 Series Owner's Manual

PRIMING YOUR
NINJA HOT & COLD BREW SYSTEM™
Clean all accessories before your first
brew. Plug in unit and power it on.
1
To fill the water reservoir, use the hand
grips to lift it to the right and up off the
brewer
2 Flip the reservoir lid open or remove
the entire lid, then add fresh, filtered
water up to, but not exceeding,
the Max Fill line
NOTE: The unit will flash the tea and
coffee icons on the control panel if there
is no removable filter holder in place.
3 Return the water reservoir to the
brewer. DO NOT fill water reservoir with
anything other than water, as other
liquids may damage your brewer.
8
1-877-646-5288
4 Ensure one of the removable filter
holders is nested inside the brew basket
5 Once in place, slide the brew basket all
the way in until you hear a slight click
6 Twist the brew-through lid clockwise
onto the carafe to lock into place and
center the carafe below the brew basket
NOTE: Do not place any ground coffee
or tea in the brew basket for the first
cycle.
7 Once all parts are securely in place the
Full Carafe size and Classic Brew setting,
then press the START/SELECT dial.
5 When the cycle is complete, discard
the water in the carafe. You are now
ready to use your Ninja Hot & Cold
Brew System to brew.

HIGH-ALTITUDE CALIBRATION

Required for users in high-altitude
areas. Not running the high-altitude
calibration brew in a high-altitude
area will result in excessive steaming
during brewing.
Because water boils at lower temperatures
at higher altitudes, running a calibration
cycle before your first brew allows the unit
to detect the boiling point of water at your
location. Running a calibration cycle will
help deliver a consistent brew each time.
1. Fill the water reservoir up to, but not
exceeding, the Max Fill line.
2. Place an empty filter holder into the
brew basket, and an empty vessel in
the machine.
3. Press and hold both the Drip Stop
button and the Tea button until
the clock display begins a two-minute
countdown.
4. A calibration cycle will begin. When
complete, the unit will beep and
End will appear on the clock display.
Discard the water in the vessel.
NOTE: Pressing the Drip Stop button
Tea button , or Power button will
cancel the calibration cycle.
NOTE: This calibration is permanently
saved an will not be lost if power is lost
or brewer is unplugged. Brewer can be
re-calibrated at any time if the altitude
where it is being used changes,
ninjakitchen.com
,
9