Using The Control Panel; Smart Sensing Mode Indicators; Preparing For Use; Setting The Clock - Ninja DUALBREW CFP200 Series Owner's Manual

USING THE CONTROL PANEL

12
13
1
2
3
4
5
6
1 Power Button
2 Hot Water Indicator
(Not included on all models)
3 Keep Warm Indicator (Orange)
4 Keep Warm Button
5
Delay Brew Button
6
Drip Stop Indicators
7
Multi-Serve Dial and Start/Stop Button
Not all functions are available on all models.

SMART SENSING MODE INDICATORS

MODE INDICATORS
Grounds: The Sliding Lid is slid all the way forward over the brew basket
until it is completely closed and the brewer is ready to brew grounds.
Pods: The Ninja® Pod Adapter is inserted, locked, and shut, and
the brewer is ready to brew pods.
Water: The dial on the left side of the brewer is turned to the
water droplet icon (not available on all models), and the brewer is
ready to dispense hot water.
No State: One of the above criteria has not been met.
6
1-877-646-5288
11
10
9
8
7
8 Intelligent Clean Cycle Button
9 Intelligent Clean Cycle Indicator
(Orange)
10 Brew Style Button
11 Hour/Minute Button
12 Programmable Digital Clock
and Ounce Display
13 Smart Sensing Mode Indicators
STATE

PREPARING FOR USE

SETTING THE CLOCK

When the brewer is first plugged in, the time will need to be set.
1
Press the HR/MIN button to set the clock.
2 Use the Multi-Serve Dial to select the correct hour. Then, press the START BREW
button to toggle to minutes.
3 Use the dial again to select the correct minute, and press the START BREW button
to set the clock at the displayed time.
NOTE: At any time, you can set the clock by pressing the HR/MIN button, and
following steps 2 and 3.
NOTE: If you unplug the brewer or in the event of a power loss, you will need to reset
the clock the next time the brewer is plugged in.

HIGH-ALTITUDE CALIBRATION BREW

Required for users in high-altitude areas. Not running the high-altitude calibration brew in
a high-altitude area will result in excessive steaming during brewing.
Because water boils at a lower temperature at higher altitudes, running a calibration
cycle before your first brew allows the brewer to detect the boiling point of water at
your location. Running a calibration cycle will help deliver a consistent brew each time.
1 Fill the water reservoir up to, but not exceeding, the Full line.
2 Insert the brew basket and slide the sliding lid closed, then place an empty carafe
on the base.
3 Press and hold both BREW STYLE and HR/MIN until you hear a confirmation sound.
4 A calibration cycle will begin, and the display will count down until the Altitude
calibration is complete. When complete, the brewer will beep and display "End"
on the dial. Discard the water in the carafe.
NOTE: This calibration is permanently saved and will not be lost if power is lost
or brewer is unplugged. Brewer can be recalibrated at any time if the altitude where it is
being used changes.
7
ninjakitchen.com