Operation Manual - Sharp CD-BA300 Service Manual

CP-BA300
1.
Subwoofer
2.
Bass Reflex Duct
3.
Tweeter
4.
Woofer
5.
Speaker Wire for
SUBWOOFER Terminals
6.
Speaker Wire for MAIN Terminals
Setting the Clock
In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button and within 5 seconds, press the
MEMORY/SET button.
3
Press the TUNING/TIME ( or
24-hour display and then press the MEMORY/SET button.
"AM 12:00"→ The 12-hour display will appear. (AM 12:00 - PM 11:59)
"AM 0:00" → The 12-hour display will appear. (AM 0:00 - PM 11:59)
→ The 24-hour display will appear. (0:00 - 23:59)
"0:00"
Note that this can only be set when the unit is first installed or it has been reset
All manuals and user guides at all-guides.com
Left speaker
1
2
Right speaker
3
4

OPERATION MANUAL

) button to select the 12-hour or
– 5 –
3
4
1
5
2
6
4
Press the TUNING/TIME ( or
then press the MEMORY/SET button.
Press the TUNING/TIME ( or
hour. Hold it down to advance continuously.
When the 12-hour display is selected, "AM" will change automatically to "PM".
5
Press the TUNING/TIME ( or
and then press the MEMORY/SET button.
Press the TUNING/TIME ( or
minute. Hold it down to change the time in 5-minute intervals.
The hour will not advance even if minutes advance from "59" to "00".
The clock begins counting from "0" seconds. (Seconds are not displayed.)
The time display will disappear after a few seconds.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or after unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
If the time display is flashing, step 3 (for selecting the 12-hour or 24-hour display) will
be skipped.
To change the 12-hour or 24-hour display:
1. Clear all the programmed contents.
[Refer to step 3 under "If trouble occurs" .]
2. Perform "Setting the Clock" from the beginning.
CD-BA300
5
6
) button to adjust the hour and
) button once to advance the time by 1
) button to adjust the minutes
) button once to advance the time by 1