Table of Contents
Advertisement
Drawing 3. Regulation of tightening of belt:
1/tightening bolt, 2/tightener, 3/regulation nut, 4/V-belt
.
4.7Mounting BALTIMATIC
Mounting of BALTIMATIC
Disassembled draw bar from lower lift arms. Drive tractor close to frame of Hay Tedder
Stop tractor, use hand brake, turn off -tractor engine and take out tractor key.
Mount top link to top of 3 point hitch on tedder and secure by using linch pins. Lift up lift
arm supports of frame on tedder – mount these to lift arms on tractor and secure by linch
pins. Tighten side chains of lower lift arms on the tractor.
Mount PTO shaft to BALTIMATIC
outside pipe, Tedder side on shaft is inside pipe).
Secure chains of shield of PTO shaft to shield of machine shaft and tractor.
ATTENTION it is prohibited to mount hay tedder to tractor
at the same time tractor us running. Turn off tractor and
remove key prior connecting
tractor.
1.
2.
®
Hay Tedder to tractor
®
Hay Tedder to tractor should be done in following steps:
®
Hay tedder and to tractor. ( Tractor side on shaft is
Page 8.
BALTIMATIC
.
3.
®
hay tedder to
4.
Advertisement
Table of Contents
