Table of Contents
Advertisement
5.3 Greasing instruction
Please keep the relevant greasing periods mentioned in table 3.
Prior greasing all greasing point – greasezerks should be cleaned.
TABLE 3. GREASING PLACES
LOCATION OF GREASE ZERKS
Hubs of wheel holder for driving wheels
Bushings/bearings on wheels
End of PTO shaft
5.4 Mounting V-belt
-Place the V-belt down on the ground
-Belt should be placed as shown on drawing 5. Having shape of number 8
-Drive backward with the tedder machine toward the belt on the ground
as shown on drawing 5.
-Mount V-belt according to drawing 2. (page 6).
-While mounting V-belt move/turn the belt pulleys
in opposite direction than the pulleys are turning during ordinary work.
-Put attention to that V-belt after mounting has the correct position
-tighten belt by using tightener. The slack of the V-belt between belt pulley and
tightnere should be approx 6' (15 mm) when a force of 110 lbs (50 N) is applied to the
V-belt.
Drawing 5. Preparation of belt for mounting on machine
.
.
Page 11
FREQUENCY
Each 20th. Hour of work
Each 20th. Hour of work
After daily work
TYPE OF GREASE
LT- 43
LT- 43
LT- 43
Advertisement
Table of Contents
