Baltic BALTIMATIC HAY TEDDER Owner's Manual page 4

*Securing of BALTIMATIC ® hay tedder lift pins to tractors lift arms should be done only
by using typical safety parts like linch pins.
*Support leg of frame is an integral part of machine. It is not allowed to remove support leg.
*Check always before work with BALTIMATIC
always before parking of teder the position of support wheels and support leg.
* BALTIMATIC ® Hay tedder should be lifted up smoothly, without rapid move.
*Transport of machine can start after the correct connection of machine with tractor and
lifting up to transporting level.
* BALTIMATIC ® Hay Tedder transported on hitch system of tractor on public roads must
be equipped with warning lights and triangle plates – relevant to local regulations.
*Every time before work of machine, check the conditions of bolted connections of spring
fingers to the arm and arms to disc of belt pulley.
*During work of BALTIMATIC ® Tedder it should not be over weighted by additional
weight.
*It is not allowed work w/o shield for PTO shaft and rotor barriers
*Ensure that no one person or animals are near machine during work.
* Maximum allowed PTO rotation is 540 rpm
*Always prior making left/right turns and prior driving backwards disconnect
PTO power and lift up tedder.
*It is not allowed driving backwards when machine is in working position
*Maximum allowed slope during work with tedder is 12 degree
*Tractor working with BALTIMATIC ® Tedder must be equipped with standard front
weights
*Removing of materials and objects from the machine must only be done
when tractor engine is turned off and when machine is lowered to the ground.
*Special attentions when BALTIMATIC ® tedder is mounted to tractor should be observed
during turning, during transport and when driving backwards.
Page 3.
®
tedder position of support wheels. Check