Equipment; Preparation Of Tractor For Work With Tedder; Preparation Of Tedder For Wo Rking - Baltic BALTIMATIC HAY TEDDER Owner's Manual

MAXIMUM TRANSPORT SPEED
WORKING SPEED
SUPPORT WHEEL SYSTEM
Number of wheels
spacing of wheels
Dimensions – diam
Dimensions – width
POWER TAKE OF SHAFT – PTO
Power size
Nominal transmission of power
Lenght
Yoke ends
Revolution

4.4 Equipment

With BALTIMATIC ® Hay Tedder should be supplied owners manual with instructions and
sparepart catalogue.
4.5 Preparation of tractor to work with BALTIMATIC ® hay tedder
Preparation of tractor to work with BALTIMATIC ® Hay Tedder should be made in
accordance to general instruction in owners manual for the tractor.
Lift arm pins on the tractor should be adjusted to same height as the lift arm pins on the
tedder. That will make it easier to mount BALTIMATIC ® tedder to tractor.
4.6Preparation of machine for work
Check BALTIMATIC ® tedder that it is in correct technical condition.
- Check bolt connections of springs to arms
- Check bolt connections of arms to belt pulley
- Check springs for wear and broken springs
In case of worn or damaged springs these must be replaced
- Check condition of V-belt, if damaged or worn-out it should be
Replaced with a new one.
- Check the tension of V-Belt. Belt must not be loose.
If regulation of tension is necesserary it can be done by nut (3) on
drawing 3. The slack of the V-belt between belt pulley and tightnere
should be approx 6' when a force of 110 lbs is applied to the V-belt.
- Checking if support wheels are turning slightly, without stopping
Remember every time before work, to check technical
condition of spring fingers, bolt connections of springs to
arms and bolt connections of arms to belt pulley.
Page 7.
US
km/h miles/h
km/h miles/h
pcs. pcs.
mm inch
mm inch
mm inch
Nm Nm
kW kW
mm inch
splined splined
rpm rpm
- Mount PTO shaft on machine.
.
US
9.2 6
6 - 12 4 - 8
2 2
1400 55 1/6"
380 15"
160 6 1/3"
210 210
12 12
460 18 1/6"
6 6
540 540