Display Layout - Wolf CWL-2-400 Installation And Operating Instructions Manual

Display
6.2

Display layout

The screen is divided up into 6 zones where various symbols/displays can be shown per zone.
Layout of main screen
The various symbols can be shown on the display. This depends on the screen that is shown, the version
of the appliance and any connected accessories.
Zone
Symbol on display Description
no.
1
2
7100833_202010
By pressing here you get access to the information menu; here one can only read out
values. It is not possible to change these values.
By pressing here you get access to the settings menu. In this menu you can change the
various values. For all setting values of standard appliance (® Setting values standard
appliance page 46). The Plus version of the appliance has various setting values (®
Setting values appliance with Plus pcb page 49).
Caution: Incorrect settings can disrupt the operation of the appliance!
Use these arrows to go up or down the various menus or to increase or decrease the values
of the relevant settings.
This arrow takes you back one step in the menu.
This takes you back to the main screen.
Filter message symbol; this is only shown if the filter has to be cleaned or replaced. See
chapter "Filter cleaning" (® Cleaning filter page 28) for more information.
This symbol is only shown if a fault has occurred in the appliance; see chapter Faults (®
Fault analysis page 25) for more information.
1 = Navigation screen
2 = Notification screen
3 = Screen with main function
4 = Connectivity information
5 = Time
6 = Date
WOLF GmbH | 19
xxxx