Table of Contents
Advertisement
Connecting to the gas supply
The inlet to the appliance is ISO 7 - Rp
situated towards the top right corner of the rear.
Fit the bayonet connection. This should be located so as
to ensure that the flexible hose does not kink.
Use a 900mm - 1125mm length of flexible hose.
Ensure that all pipe work is of the correct rating.
Natural Gas - Flexible connections should comply with
BS 669. Parts of the appliance likely to come into contact
with a flexible connector have a temperature of less than
70˙C.
LP Gas - For flexible connections use a bayonet type
hose, suitable for use on LP Gas up to 50mbar pressure
rise and 70˙C temperature rise. The flexible hose should
be coloured black with a red stripe, band or label. If in
doubt, contact your supplier.
For conversion to LPG, a conversion kit can be purchased.
Contact the Electrolux helpline, quoting kit reference
012860201.
After installation make sure all connections are gas
sound.
Pressure settings:
G20 Natural Gas @ 20mbar
G30 Butane @ 28-30mbar
G31 Propane @ 37mbar
Turn on gas supply and check for soundness at the hot-
plate injector. Light two burners and check that the pres-
sure is correct.
Turn the control knob to the full on position and allow the
grill to operate for a few minutes.
Turn the control knob to the full on position and allow the
oven to operate for a few minutes
All manuals and user guides at all-guides.com
Installing Your Cooker
1
Commissioning
Hob
Grill
Oven
.
" internal thread
⁄2
25
Advertisement
Table of Contents
