Hanging The Fan - Hunter Anorak Installation Manual

1886
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
1
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.
Hunter Pro Tip:
The adapter cover is not used for
low-profile mounting.
4
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
5
Ceiling Bracket Downrod
Installing the Downrod
2
Remove the pre-installed
setscrew so that the
downrod can be inserted.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.

Hanging the Fan

Hanging Fan Wiring
3
5
Lower the adapter cover until it rests flush
against the motor housing.
Canopy Blades
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
Pass all wires to one side of horizontal bar
in downrod assembly. Hand tighten the
downrod (at least 4–5 full turns) until it
stops. Trim the wires coming from the fan
so that 8-inches remain coming from the
top of the downrod.
Note:
Fan style may vary.
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Place the downrod ball into
the slot in the ceiling bracket.
Light Glass Control