Table of Contents
Advertisement
1886
1
Turning off the power
Ensure the power
is OFF at the outlet
box and wall switch
location before
proceeding with
installation.
OFF
OFF
4
Installing the Wall Control
Install the longer screws
through the slots in the wall
control into the switch box
screw holes.
8
Reference the included remote function card for
information on how to use your wall control!
Remote Function Guide
Key Press
Long
Press
Long
Press
Long
+
Press
Long
Press
Long
Press
9
Ceiling Bracket
Downrod
Preparing the Wall Control
2
Installing the battery
To access the battery
compartment, slide the battery
door up.
Replace the used battery with
two AAA batteries when needed.
Battery
Door
5
Installing the Wall Plate
Install the shorter screws
through the wall control
plate and into the screw
holes in the wall control.
Function
Light On/Off
Light Dimming
Control
Light High
Light Low
Dimming Mode
On/Off
Fan On/Off
Fan Speed
Control
Fan High
Fan Low
Power On/Off
Hanging Fan
3
Wiring the Wall Control
Connect the grounding wire
from the wall control to the
ground control from the switch
box using the provided wire
nuts.
Connect the "LIVE IN" from
the switch box to the "~VAC"
from the wall control using the
provided wire nuts.
Connect the "LIVE OUT" from
the switch box to the "FAN" out
from the wall control using the
provided wire nuts.
Push all wires into the switch
box.
6
Turning on the power
IMPORTANT
Use the pull-chain
switch on the fan to set
the fan speed to the
HIGH position before
operation.
ON
ON
Wiring
Canopy
Remote Function Guide
Key Press
Long
Press
7
The remote transmitter is already paired to
Long
the receiver and ready to use. If you need
Press
to pair your remote, cycle power to the fan
by turning power off and back on at the
Long
wall switch (or circuit breaker if necessary).
+
Within three minutes, do the following:
Press
NOTICE
Long
Press
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
Long
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
Press
interference received, including interference that
may cause undesired operation.
Blades
Light
Function
Light On/Off
Light Dimming
Control
Light High
Light Low
Remote Fu
Dimming Mode
Key Press
On/Off
Fan On/Off
Fan Speed
Control
Long
Fan High
Press
Long
Fan Low
Press
Long
+
Press
Power On/Off
Long
Press
Long
Press
Glass
Control
Advertisement
Table of Contents
