Table of Contents
Advertisement
bag
Partially install two switch housing screws, found
in the
hardware bag, through the gasket
halfway into the motor housing as shown. It does
not matter which two screw holes you choose.
Lift the the lower switch housing and
connect the plugs. Make sure to line up the
colored markings on the connectors and
that the connectors latch.
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
Ceiling Bracket
Downrod
Assembling the Light
2 of 3
Switch Housing
Screw
Feed the wire plug through the center hole of the uppers
switch housing. Align the keyhole slots in the upper
switch housing with the two screws you just installed.
Lift the upper switch housing so that the keyhole slots
engage the two screws, and twist counterclockwise to
lock the upper switch housning into place.
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan
Wiring
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Note:
Fan style may vary.
Canopy
Blades
bag
Insert the third screw found in the
hardware bag, into place and then tighten all
three screws.
3 of 3
Short Housing
Screw
bag
Using the three short housing
screws found in the
hardware
bag, mount the lower switch
housing to the upper switch housing.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Glass
1886
1 of 3
Switch Housing
Screw
ON
8
Control
Advertisement
Table of Contents
