Table of Contents
Advertisement
DisplayPort output connector — Connect a video display to this
H
DisplayPort connector.
Audio output connector — This 5-pole, 3.5 mm captive screw connector outputs
I
the transmitted, unamplified, line level analog audio. Connect an audio device, such as
an audio amplifier or powered speakers.
See figure 5 to properly wire a captive screw output connector. Use the supplied
tie-wrap to strap the audio cable to the extended tail of the connector.
Do not tin the wires!
Unbalanced Stereo Output
Figure 5.
Captive Screw Connector Wiring for Stereo Audio Output
ATTENTION:
•
For unbalanced audio, connect the sleeves to the ground contact.
DO NOT connect the sleeves to the negative (-) contacts.
•
Pour l'audio asymétrique, connectez les manchons au contact au sol.
Ne PAS connecter les manchons aux contacts négatifs (–).
NOTES:
•
The length of exposed wires is important. The ideal length is 3/16 inch (5 mm).
•
If the stripped section of wire is longer than 3/16 inch, the exposed wires
may touch, causing a short circuit.
•
If the stripped section of wire is shorter than 3/16 inch, wires can be easily
pulled out even if tightly fastened by the captive screws.
•
Do not tin the power supply leads before installing them in the connector.
Tinned wires are not as secure in the connector and could be pulled out.
Over TP RS-232 and IR connector — Connect a serial RS-232 signal,
J
a modulated IR signal, or both to this 3.5 mm, 5-pole captive screw
connector for bidirectional RS-232 and IR communication
(see
RS-232 and IR connector wiring
Power input connector — Plug the included external 12 VDC power supply into either
K
this 2-pole connector or the power input connector on the transmitter (see
the previous page).
ATTENTION:
•
Do not connect power to the DTP DP 330 or DTP DP 230 until you have read
the
CAUTION
and
•
Ne branchez pas l'alimentation au DTP DP 330 ou DTP DP 230 avant d'avoir lu
les deux rubriques «
NOTE: When the TP function switch (see
position, one power supply can power both units.
When the TP function switch is in the HDBT position, the transmitter
and receiver each requires a local 12 VDC power supply.
DTP DP 330 and DTP DP 230 Twisted Pair Extenders • Installation and Operation
NO GROUND HERE
Tip
Ring
Tip
Sleeves
Tip
Tip
Ring
NO GROUND HERE
Balanced Stereo Output
on page 9 to wire the connector).
ATTENTION
notices on pages 8 and 9.
ATTENTION
» aux pages 8 et 9.
item
RS-232
Tx Rx
item
on page 4) is in the DTP
D
OVER TP
IR
G
Tx Rx
on
F
6
Advertisement
Table of Contents
