Daikin FTXS-L Series Engineering Data page 68

EDUS091128
Indoor Unit Installation Drawings
B
3/16" × 1" (M4 × 25mm)
Front panel
1-15/16" (50mm)
or more from walls
(on both sides)
C Titanium apatite photocatalytic
Filter frame
Tab
INTELLIGENT EYE sensor
CAUTION
Split Type Air Conditioners FTXS-L / FDXS-L Series
A Mounting plate
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
M Screw cover (3 pcs)
3/16" × 5/8"
(M4 × 16mm)
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Titanium apatite
photocatalytic air
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
Front grille
release, remove the front grille.
1-3/16" (30mm)
or more from ceiling
Caulk
pipe hole
gap
with putty.
INTELLIGENT EYE
sensor
Service lid
D
Wireless
remote
controller
F Fixing screw for remote
controller holder
1/8" × 13/16" (M3 × 20mm)
Installation Manual
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the thermal insulation
from bottom to top.
Before screwing the remote
controller holder to the wall,
make sure that control
signals are properly
received by indoor unit.
E
Remote
controller holder
67