Renesas QB-RL78G13 User Manual page 11

QB-RL78G13 In-Circuit Emulator
(1) TCN1, TCN2, TCN3
These are connectors for connecting a check pin adapter or emulation probe.
(2) OSC1
This is a socket for mounting the oscillator.
(3) CN6
This is a connector for the shipment inspection. It is not something that the user will need.
(4) POWER (Red LED)
This is an LED that shows whether the power supply of the QB-RL78G13 is switched on.
LED State
Lit
Not lit
Blinking
(5) TARGET (Green LED)
This is an LED that shows whether the power supply of the target system is switched on.
LED State
Lit
Not lit
(6) Power switch
This is the power switch of the QB-RL78G13.
It is OFF at shipment.
(7) Cooling fun
This is the cooling fun of the QB-RL78G13.
It works when the power supply of the QB-RL78G13 is switched on.
R20UT0764EJ0200 Rev.2.00
2012.03.30
Power switch ON
Power switch OFF or AC adapter not connected to QB-RL78G13
Internal error occurred (Contact an Renesas Electronics sales representative or
distributor)
Target system power supply ON
Target system power supply OFF or target system not connected
QB-RL78G13 State
Target System State
CHAPTER 1 GENERAL
Page 10 of 44