JVC XV-M565BK Service Manual page 17

Removing the cams R1/R2 assembly
and cam gear L
1. Remove the slit washer fixing the cams R1 and R2
assembly.
2. By removing the two pawls s fixing the cam R1,
separate R2 from R1.
3. Remove the slit washer fixing the cam gear L.
4. Pull out the cam gear L from the C.G. base assembly.
Removing the C.G. base assembly
Remove the three screws L retaining the C.G. base
assembly.
[Caution] To reassemble the cylinder gear, etc.with the
cam unit (cam gear and cams R1/R2 assembly),
gear unit and drive unit, align the position of the
pawl n on the drive unit to that of the notch on
the cam gear L. Then, make sure that the gear
unit is engaged by turning the cam gear L
(See Fig.23)
(See Fig.23 and 24)
(See Fig. 24).
Slit washer
Cam gear L
L
Fig.23
Cam gear L
Notch
n
Pawl
Cylinder
gear
Drive unit
Fig.24
XV-M565BK/M567GD
Slit washer
Cam R2
s
s Pawl
Pawl
Cam R1
Cam switch board
C.G. base assembly
Cam R1, R2 assembly
Gear unit
Gear bracket
1-17