JVC XV-M565BK Service Manual page 11

<DVD Changer Mechanism Assembly>
Prior to performing the following procedure, remove
the top cover and the DVD changer mechanism
assembly.
Removing the traverse mechanism
control board (See Fig.18)
1. Disconnect the card wire from connector CN101 on
the traverse mechanism control board on the bottom
of the DVD changer mechanism assembly.
2. Remove the screw L attaching the traverse
mechanism control board. Release the three parts e,
f and g and remove the traverse mechanism control
board.
3. Disconnect the card wire from connector CN102 on
the traverse mechanism control board.
Ejecting the DVD (See Fig.19 and 20)
When the DVD is set or the traverse
mechanism is up.
The DVD tray can not be ejected when the traverse
mechanism is up.
Bringing down the traverse mechanism
as shown in the Fig.20
1. The motor pulley and the belt can be seen on the
front side of the changer. Turn the motor pulley
clockwise until the belt stops.
2. Pull the tray lock lever on the left side of the changer
and draw the DVD tray.
3. Draw the DVD tray 1 to 3 as above.
DVD changer mechanism assembly
Part e
Part f
Fig.18
Fig.19
Traverse mechanism
As the motor pulley is
turned, the traverse
mechanism lowers.
Fig.20
XV-M565BK/M567GD
L
DVD traverse
mechanism
control board
CN102
CN101
Part g
Belt
Motor pulley
Draw the DVD tray.
Tray stopper
Tray lock lever
1-11