JVC XV-M565BK Service Manual page 16

XV-M565BK/M567GD
Removing the actuator motor and belt
1. Remove the two screws K retaining the gear bracket
2. While pressing the pawl p fixing the gear bracket in the
arrow direction, remove the gear bracket
3. From the notch q section on the chassis assembly fixing
the edge of gear bracket, remove and take out the gear
bracket(See Fig. 20).
4. Remove the belts respectively from the right and left
actuator motor pulleys and pulley gears(See Fig. 19).
5. After turning over the chassis assembly, remove the
actuator motor while spreading the four pawls r fixing
the right and left actuator motors in the arrow
direction(See Fig. 21).
[Note] When the chassis assembly is turned over under
the conditions wherein the gear bracket and belt
have been removed, then the pulley gear as well
as the gear, etc. constituting the gear unit can
possibly be separated to pieces. In such a case,
assemble these parts by referring to the assembly
and configuration diagram in Fig. 22.
Chassis assembly
Assembly and Configuration Diagram
1-16
(See Fig.19
(See Fig.19).
(See Fig.19).
q
Gear bracket
Fig.20
Pulley gear
Gear B
Gear C
22)
Pulley gear
Belt
Motor pulley
r
Pulley gear
Gear B
Select gear
Gross gear L
Fig.22
Gear bracket
K
Fig.19
Actuator motor
Fig.21
Cylinder gear
Gross gear U
Gear C
Pulley gear
Belt
Motor pulley
K
p
Pawl
r