Table of Contents
Advertisement
16
INSTALLING THE MAGICFALLS
Note: Prepare the end of the MagicFalls LED light power cable and install to the 12
VAC output wires of an approved transformer (if you are using longer runs of cables
or multiple lights per transformer, it is recommended to use the 13 VAC or even the 14
VAC tap on your transformer).
1.
A, 1" – PVC electrical conduit must be installed from the pool light power
sup-ply/transformer location to the bottom of the waterfall electrical port.
2.
Only install the Light after your finish work is complete to avoid causing any
damage to the Light Lens and housing.
3.
Ensure waterfall light niche is free of any construction debris prior to
installation, this includes the keyway that the waterfall locks into.
4.
Turn off main electrical switch or circuit breaker.
5.
Feed cord through waterfall and then through conduit to Junction Box or 12
Volt AC Transformer.
NOTE: This is a 12 Volt AC system ONLY. An approved 12 VAC
transformer (sold separately) must be used. If a Junction Box is
used, it would be for 12 VAC connections. Never wire the MagicFalls
with LightCascade Technology™ light directly to high voltage lines.
6.
At the 12 VAC transformer or junction box, cut off any extra cord. Leave at
least six (6) inches (15.2 cm) of cord in the Junction Box or transformer to
facilitate the light installation, niche inspection. Cut off any extra cord.
7.
Strip back three (3) inches of the outer cord jacket to expose the two
insulated wires (be careful not to damage the insulation on the two (2) inner
wires). Strip back the two conductors. Be careful not to damage the copper
conductor.
8.
Connect both (2) wires to the corresponding circuit wires in the Junction Box
or 12 Volt AC Transformer (black wire to power, white wire to common) and
secure the Junction Box cover in place.
MagicFalls with LightCascade Technology LED Light Installation and User's Guide
(AFTER WATERFALL INSTALLATION)
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Always disconnect power to the pool light at the circuit breaker
before servicing the light. Failure to do so could result in death
or serious injury to installer, service person, pool users, or
others due to electrical shock.
LED LIGHT ASSEMBLY
®
D A N G E R !
®
Advertisement
Table of Contents
