Table of Contents
Advertisement
Operating MagicFalls
MagicFalls Water Effect can be controlled using a standard wall-mount light switch.
Multiple MagicFalls Water Effect can be connected via a junction box to a single switch
so that all lights can be switched on and off together. The lights are controlled by
cycling the AC power to the 12 VAC power supply and from there to the lights from a
standard wall switch. By turning the switch OFF and ON a specific number of times,
the light activates one of the seven light show modes, fixed colors, or enables the
"Hold" and "Recall" feature.
Note: Wall switch must be connected to the 120 VAC side of the transformer and
never to the 12 VAC side.
Operating MagicFalls Water Effect Using Automation Control
System
MagicFalls Water Effect can also be automatically controlled via a Pentair Color
Sync™, IntelliCenter
mation refer to the user manual of your automation control system.
Using an External Transformer for Multiple MagicFalls Water
Effects
When using multiple MagicFalls
on a 100 Watt transformer, it is recommended that no more than three (3) MagicFalls
LED lights be used. It is also recommended not to exceed 150 feet of total cable run
between the transformer and lights. Note: For long cable lengths, set transformer to 14
VAC, and use only MagicFalls LED lights with the 150" cord option, see diagram below.
100 Watt
Transformer
Note: If a longer cable run is necessary, it is recommended that separate 100 Watt 12 VAC
transformers be used for each light with no more than 150 feet of total cable run between the
transformer and lights.
Water Effect Using a Wall Switch
®
, IntelliTouch
and EasyTouch
®
®
with LightCascade Technology™12 VAC LED Lights
®
12 Gauge
J Box
(Minimum)
150 ft.
MagicFalls with LightCascade Technology LED Light Installation and User's Guide
Control Systems. For more infor-
®
5
Advertisement
Table of Contents
