Installing The Magicfalls With Lightcascade Technology - Pentair MAGICFALLS Installation And User Manual

With lightcascade technology
Table of Contents

Advertisement

10
Important General Precautions - Read this Information Before Installation
The MagicFalls Water Effect niche is designed for 1-1/2 in (3.81 cm) PVC pipe for
the water supply and 1 in (2.54 cm) electrical conduit for the light cable.
Water line should be installed with an adjustable control valve so you can adjust the
water flow to the waterfall for desired effect.
Waterfall requires a 1 ½" water line connection from the pump/filter for waterfalls up
to 3' in length and a 2" water line connection for waterfalls 3' and above.
Multiple waterfalls should not be connected to the same supply line, unless your
using a looping type configuration to equalize pressure to all waterfalls.
For installation subject to heavy debris, install the optional rock trap (P/N 580004).
This requires 2 in plumbing.
The waterfall should be installed so that the water flowing out of the waterfall is
flowing into the pool, spa or fountain.
The waterfall must be installed level or water will not flow out evenly from the spout.
Should water start to drip from the underside of the spillway, the water flow should
be adjusted to a flow rate that eliminates or minimizes the drips. Some water
dripping may be unavoidable due to water flow, surface conditions, or irregularities
on the lip.
If the MagicFalls LED light assembly is not installed properly in the waterfall, the
LED light will be damaged and the warranty void.
If the MagicFalls™ LED light assembly is not installed properly in the waterfall,
water may leak into the electrical conduit.
Splicing of the light engine cable is not permitted unless done in a waterproof
junction box. An unapproved wire splicing will void the warranty.
The electrical junction box must be installed above the highest water level of the
waterfall. If the junction box is installed below the top level of the waterfall, water
may leak from the waterfall into the conduit and fill the junction box with water.
MagicFalls with LightCascade Technology LED Light Installation and User's Guide
INSTALLING THE MAGICFALLS
LIGHTCASCADE TECHNOLOGY™
WITH
®

Advertisement

Table of Contents
loading

Table of Contents