Table of Contents
Advertisement
Pairing the Computer with the Camera
The camera and computer must be paired in order to connect. Up to four computers
can be paired with the camera at a time. To pair a computer with the camera, connect it
via USB. Pairing need only be performed once per computer.
After confirming that the camera is off, connect it to the computer using the
1
USB cable.
• When attaching the USB cable, use the supplied cable protector and cable clip to
prevent damage to the connectors. g "Attaching Cable Protectors" (P. 19)
• The locations of USB ports vary from computer to computer. See the documentation
provided with the computer for information on USB ports.
• If the USB port on the computer is Type A port, use the optional CB-USB11 cable.
2
Turn the camera on.
• The camera will display a message prompting you to identify the device to which the
USB cable is connected.
%If the message is not displayed, select [Select] for [USB Mode] (P. 252).
# If the batteries are very low, the camera will not display a message when connecting
to a computer. Be sure the batteries are charged.
Highlight [0RAW/Control] using FG on the
3
arrow pad and press the Q button.
4
Launch the copy of "OM Capture" installed on the
computer.
• After starting up, "OM Capture" will prompt you to
choose the connection type.
USB port
(New Link)
P A S M B
USB connector
USB cable (supplied)
USB
Storage
MTP
0RAW/Control
USB PD
Exit
n
8
OK
269
EN
Advertisement
Table of Contents
