Cisco Firepower 2100 Getting Started Manual page 72

Central Administrator Pre-Configuration Using FDM
b) Configure the Time Setting (NTP) and click Next.
1. Time Zone—Select the time zone for the system.
2. NTP Time Server—Select whether to use the default NTP servers or to manually enter the addresses
of your NTP servers. You can add multiple servers to provide backups.
c) Select Start 90 day evaluation period without registration.
Do not register the FTD with the Smart Software Manager; all licensing is performed on the FMC.
d) Click Finish.
e) You are prompted to choose Cloud Management or Standalone. For FMC management, choose
Standalone, and then Got It.
Step 5
(Might be required) Configure the Management interface. See the Management interface on Device >
Interfaces.
The Management interface must have the gateway set to data interfaces. By default, the Management interface
receives an IP address and gateway from DHCP. If you do not receive a gateway from DHCP (for example,
you did not connect this interface to a network), then the gateway will default to data interfaces, and you do
not need to configure anything. If you did receive a gateway from DHCP, then you need to instead configure
this interface with a static IP address and set the gateway to data interfaces.
Step 6 If you want to configure additional interfaces, including an interface other than outside or inside that you want
to use for FMC access, choose Device, and then click the link in the Interfaces summary.
See Configure the Firewall in Firepower Device Manager, on page 22
interfaces in FDM. Other FDM configuration will not be retained when you register the device to FMC.
Step 7 Choose Device > System Settings > Management Center, and click Proceed to set up FMC management.
Step 8
Configure the FMC Details.
Cisco Firepower 2100 Getting Started Guide
70
Firepower Threat Defense Deployment with a Remote FMC
for more information about configuring