Cisco Firepower 2100 Getting Started Manual page 163

Firepower Threat Defense Deployment with CDO
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see the
Step 3 To exit the FTD CLI, enter the exit or logout command.
This command returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?.
Example:
> exit
firepower#
Power Off the Firewall Using FDM
You can shut down your system properly using FDM.
Procedure
Step 1
Use FDM to shut down the firewall.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2
Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
What's Next
To continue configuring your FTD using CDO, see the CDO
For additional information related to using CDO, see the
Cisco Firepower Threat Defense Command
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Power Off the Firewall Using FDM
Reference.
Configuration Guides.
Cisco Defense Orchestrator
Cisco Firepower 2100 Getting Started Guide
home page.
161