Cisco Firepower 2100 Getting Started Manual page 206

(Optional) Enable Additional Interfaces in the Firepower Chassis Manager
Note For many interface show commands, you either cannot use the ASA commands or the commands lack the
full statistics. You must view more detailed interface information using FXOS commands:
• /eth-uplink/fabric# show interface
• /eth-uplink/fabric# show port-channel
• /eth-uplink/fabric/interface# show stats
• (local-mgmt)# show portmanager counters
• (local-mgmt)# show lacp
• (local-mgmt)# show portchannel
See the FXOS troubleshooting guide
Before you begin
• Log into the Firepower Chassis Manager. See
page
• The Firepower 2100 supports EtherChannels in Link Aggregation Control Protocol (LACP) Active or
On mode. By default, the LACP mode is set to Active; you can change the mode to On at the CLI. We
suggest setting the connecting switch ports to Active mode for the best compatibility.
• To change the management IP address from the default, see
Management IP Addresses or Gateway, on page
Procedure
Step 1
In Firepower Chassis Manager, click Interfaces.
The All Interfaces page shows a visual representation of the currently-installed interfaces at the top of the
page and provides a listing of the installed interfaces in the table below.
Step 2 To enable or disable an interface, click Enable slider (
Note
Step 3 (Optional) Add an EtherChannel.
Note
a) Click Add Port Channel above the interfaces table.
Cisco Firepower 2100 Getting Started Guide
204
for more information.
203.
The Management 1/1 interface shows as MGMT in this table.
EtherChannel member ports are visible on the ASA, but you can only configure EtherChannels and
port membership in FXOS.
(Optional) Log Into the Firepower Chassis Manager, on
(Optional) Change the FXOS and ASA
197.
) or Disable slider (
ASA Deployment with ASDM
).