Table Of Contents; Clear Previous Pairing In Remote Control; Put The Hearing Aids In Pairing Mode - oticon Opn Quick Manual
Hide thumbs
Also See for Opn:
- Instructions for use manual (80 pages) ,
- Quick manual (28 pages) ,
- Quick manual (13 pages)
Table of Contents
Advertisement
Introduction
After upgrading Oticon Opn firmware, it is necessary to
re-pair the instruments with relevant accessories.
This short guide shows you how to re-pair Oticon Opn with
different types of accessories.
Please visit www.oticon.com for more details on compatibility, or see the
description of the Oticon ON App on the App Store® and Google Play™.
Apple, the Apple logo, iPhone, iPad, iPod touch, and Apple Watch are
trademarks of Apple Inc., registered in the U.S. and other countries. App
Store is a service mark of Apple Inc. Android, Google Play, and the Google
Play logo are trademarks of Google Inc.
2
Table of contents
Remote Control 3.0
TV Adapter 3.0
Remote Control 3.0
3
3
1. Clear previous pairing in remote control
3
4
5
6
6
8
10
10
Press and hold all buttons
The status LED will then
12
for 5 seconds.
glow green for about 10
seconds to confirm the
14
The status LED will flash
remote is ready for pairing.
green twice.
2. Put the hearing aids in pairing mode
Ensure that you have
Wait for about 10 seconds,
good batteries in the
until the hearing aids are
hearing aids.
fully turned on and the
power-on-jingle has been
Open the battery doors
played.
of both hearing aids.
Wait about five seconds
The hearing aids will remain
and close the battery
in pairing mode for about
doors again.
3 minutes.
3
Advertisement
Table of Contents
