Using The Gas Surface Burners - GE JGSP28SENSS Owner's Manual

Using the gas surface burners.

Throughout this manual, features and appearance may vary from your model.
Push the control knob in and turn
it to the LITE position.
8
How to Light a Gas Surface Burner
Push the control knob in and turn it to the
LITE position.
You will hear a little clicking noise—the
sound of the electric spark igniting the
burner.
After the flame lights, turn the knob to
adjust the flame size. If the knob stays at
LITE, it will continue to click.
Sealed Gas Burners
The smaller burner (right rear position) will
give the best simmer results for delicate
foods, such as sauces or foods which need
to cook over low heat for a long time. It can
be turned down to a very low setting.
How to Select Flame Size
For safe handling of cookware, never let the
flames extend up the sides of the cookware.
Watch the flame, not the knob, as you
reduce heat. The flame size on a gas burner
should match the cookware you are using.
In Case of Power Failure
In case of a power failure, you can light the
gas surface burners on your range with a
match. Hold a lit match to the burner, then
push in and turn the control knob to the
LITE position. Use extreme caution when
lighting burners this way.
Before Lighting a Gas Burner
n Make sure all grates on the range are in
place before using any burner.
When one burner is turned to LITE, all the
burners spark. Do not attempt to
disassemble or clean around any burner
while another burner is on. An electric shock
may result, which could cause you to knock
over hot cookware.
The largest burners are higher powered
than the others and will bring liquids to
a boil quicker.
Any flame larger than the bottom of the
cookware is wasted and only serves to heat
the handle.
Surface burners in use when an electrical
power failure occurs will continue to
operate normally.
After Lighting a Gas Burner
n Do not operate the burner for an
extended period of time without
cookware on the grate. The finish on the
grate may chip without cookware to
absorb the heat.
Be sure the burners and grates are cool
n
before you place your hand, a pot holder,
cleaning cloths or other materials on
them.