Oven Vent And Cooktop Air Inlet; Painted Surfaces; Stainless Steel Surfaces - GE JGSP28SENSS Owner's Manual

Care and cleaning of the range.
Oven vent
Cooktop air inlet
Oven floor
26

Stainless Steel Surfaces

Do not use a steel wool pad; it will
scratch the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.

Painted Surfaces

Painted surfaces include the top and sides
of the door, and the drawer front. Clean
these with soap and water or a vinegar and
water solution.

Oven Vent and Cooktop Air Inlet

The oven is vented through an opening in
the cooktop under the grille. The cooktop
takes in air through the air inlet located
through the cooktop.
Control Panel
If desired, the touch pads may be turned off
before cleaning.
See the Control Lockout section.
Clean up splatters with a damp cloth.
Removable Oven Floor
To remove the oven floor for easier
cleaning:
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and pull it out.
(on some models)
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer or Mabe Parts Store
nearest you, please call our toll-free
number:
National Parts Center 1.800.626.2002 (U.S.)
GEAppliances.com (U.S.)
www.GEAppliances.ca (Canada)
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
Never cover these openings with
aluminum foil or any other material. This
would prevent the vents from working
properly.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Clean the oven floor with warm soapy
water.
IMPORTANT: Always replace the
removable floor before the next use.
1.800.661.1616 (Canada)