Control Lockout - GE JGSP28SENSS Owner's Manual

Oven Control, Clock and Timer Features and Settings
– Pad
Short taps to this pad will decrease the time
or temperature by small amounts. Touch and
hold the pad to decrease the time or
temperature by larger amounts.
+ Pad
Short taps to this pad will increase the time
or temperature by small amounts. Touch and
hold the pad to increase the time or
temperature by larger amounts.
SELF CLEAN Pad
Touch this pad to select the self-cleaning
function. See the Using the self-cleaning oven
section.
CLEAN Light
Flashes while in edit mode—you can change
the length of time for the self-clean cycle at this
point. Glows when the oven is in the self-clean
cycle. After the self-clean cycle, the light will
turn off. Unlatch the door.
CONTROL LOCK/UNLOCK
PRESS + AND – AND HOLD FOR 3 SECONDS

Control Lockout

Your control will allow you to lock out the
touch pads so they cannot be activated
when touched.
To lock/unlock the controls:
Touch the + and – pads at the same
time for 3 seconds, until the display
shows LOC ON.
To unlock the control, touch the + and –
pads at the same time for 3 seconds,
until the display shows LOC OFF.
Power Outage
CAUTION:
Do not make any
attempt to operate the electric ignition
oven during an electrical power failure.
The oven or broiler cannot be lit during a
power failure. Gas will not flow unless the
glow bar is hot.
If the oven is in use when a power failure
occurs, the oven burner shuts off and
cannot be re-lit until power is restored. This
is because the flow of gas is automatically
stopped and will not resume when power
is restored until the glow bar has reached
operating temperature.
CLEAR/OFF Pad
Touch this pad to cancel ALL oven
operations except the clock and timer.
BROIL HI/LO Pad
Touch this pad to select the broil function.
BROIL Light
Flashes while in edit mode—you can switch
from HI to LO BROIL at this point. Glows when
the oven is in broil mode.
Indicator Lights (on some pads)
EDIT mode lasts several seconds after the last
pad press. START TIME ON/OFF and COOKING
TIME ON/OFF will be the only pads lit if either of
these options is selected. (Example: START
TIME is selected with BAKE—the START TIME
pad will remain lit until the clock reaches the
programmed time, at which point it will turn off
and the BAKE/TEMP RECALL pad light will light
up).
When this feature is on and the touch pads
are touched, the control will beep and the
display will show LOC ON.
The control lockout mode affects all
n
touch pads. No touch pads will work
when this feature is activated.
The adjustment will be retained in
n
memory after a power failure.
If a flashing time is in the display, electric
power has been restored. Reset the clock.
If your oven was set for a timed oven
operation and a power outage occurred,
the clock and all programmed functions
must be reset.
To reset the clock, touch the CLOCK pad.
Enter the correct time of day by touching
the + or – pads. Touch the START/ON pad.
GEAppliances.com
11