Canon DR-5060F Instructions Manual page 50

1
Set up the scanner.
2
Set the Start Scanning dialog box.
[Separator] setting
Set file separator of the image when a patch code sheet is detected.
• None
Does not separate files even if patch code sheets are detected.
• Scan, Continue Scanning
Separates files and continues scanning when the patch code sheet is
detected.
At this time, the content of the patch code sheet is recorded as an image.
• Skip, Continue Scanning
Separates files and continues scanning when the patch code sheet is
detected.
At this time, the content of the patch code sheet is not recorded as an image.
• Scan, Stop Scanning
Stops scanning when the patch code sheet is detected.
At this time, the content of the patch code sheet is recorded as an image, and
the file is separated from the image of the patch code sheet.
• Skip, Stop Scanning
Stops scanning when the patch code sheet is detected.
At this time, the content of the patch code sheet is not recorded as an image.
[2LevelBlip] setting
Set the film separator when the patch code sheet is detected.
• [2LevelBlip] marked
Marks film with a file mark when the New File key is pressed.
• [2LevelBlip] not marked
Does not mark film with a file mark when the New File key is pressed.
3
Click [Start Scanning] to start scanning.
MEMO
When scanning is set to stop when a patch code is detected, scanning is
stopped when a patch code is detected, and the Scanning Canceled dialog box
is displayed.
48
Other Scan Operations