Barcode Settings - Canon DR-5060F Instructions Manual

Barcode Settings

Make the settings for scanning barcodes. These settings are enabled only when
the optional barcode decoder is installed.
These items are set in the Barcode Settings dialog box.
Barcode Type
The following six kinds of barcodes can be recognized and scanned on this
scanner:
• UPC codes (UPC-A, UPC-E)
• AN codes
• Codabar codes
• ITF codes (including Industrial 2of5)
• Code39 codes
• Code 128 codes
Select the type of barcode to scan, and mark the check box for the type of
barcode you selected.
MEMO
When the barcode type is unknown, mark all barcode check boxes before
scanning the original so that all barcode types are automatically detected
and the checksum is not scanned.
NOTE
Barcode information is saved to the log file specified in the film address log
setting. (See "Film Address Log File" P. 60)
When [Record Log] is disabled in the film address log setting, the information
of detected barcodes is not saved to log file. So, be sure to enabled [Record to
Log] before you start scanning barcodes.
Setting Scan Conditions
3
75