Advertisement
Quick Links
Advertisement
Summary of Contents for Biktrix Bafang DPC-18
- Page 1 Bafang DPC-18 DISPLAY MANUAL Biktrix Version Normal Display Interface Button Definition:...
- Page 2 Normal Operation On/off switch To turn on the display, press and hold the ON/OFF button. Press and hold the ON/OFF button again to turn off the display. If the controls are not operated and the bike is not used for 5 minutes (this time can be set in “Auto Off”) the display will automatically turn off.
- Page 3 Display Backlight/Headlight Switch Press and hold the LIGHT button to turn on the display backlight as well as the bike headlight. Press and hold the LIGHT button again to turn off the display backlight and the headlight. There are 5 levels of backlight brightness that can be selected by the user (can be set in “Brightness”).
-
Page 4: User Settings
User Settings Detailed below is the operating process for changing the user settings Entering the “SETTING” interface. After turning on the display, briefly press the Mode button two times to enter the “SETTING” interface. This interface includes the three options: “Display setting”, “Information” and “EXIT”. Operating within the “SETTING”... - Page 5 Entering the “Display setting” interface In the “SETTING” interface, select “Display setting” and then briefly press the Mode button to confirm and enter “Display setting”. There are thirteen options in this interface. (1) “Unit” - switch units between km and mile Select “Unit”...
- Page 6 (6) “SOC View” --- set display mode for battery capacity Select “SOC View” in the “Display Setting” interface. Once selected, press the LEVEL+ or LEVEL- buttons to switch display mode for battery level as “Percent” or “Voltage”. After selecting your preferred State of Charge view, press the MENU button again to save the setting and exit back to the “Display Setting”...
- Page 7 (9) “Speed Limit” - set motor cut-off speed limit Select “Speed Limit” in the “Display Setting” interface. Once selected, press the LEVEL+ or LEVEL- buttons to select the motor speed cut-off limit as “10/11/12/…/58/59/60”. After selecting your preferred Speed Limit, press the MENU button again to save the setting and exit back to the “Display Setting”...
-
Page 8: Error Code Definition
you input the wrong password ten times, the display will turn off automatically. After inputting the right password, the display will prompt you to input a new password. The following procedure is the same as “Starting Password”. After changing the password, the display will exit automatically back to the original interface within two seconds. - Page 9 Error Code Error Definition Solution “07” High Voltage Protection Check the battery voltage “08” Fault with motor hall sensor inside Contact Biktrix support “10” The motor temperature reaches the max Stop riding and wait until the protection value LED stops flickering “12”...