Advertisement
(9) "Speed Limit" - set motor cut-off speed limit
Select "Speed Limit" in the "Display Setting" interface. Once selected, press the LEVEL+ or
LEVEL- buttons to select the motor speed cut-off limit as "10/11/12/.../58/59/60". After
selecting your preferred Speed Limit, press the MENU button again to save the setting and
exit back to the "Display Setting" interface.
(10) "AL Sensitivity" - set light sensitivity for headlight auto turn on
Select "AL Sensitivity" in the "Display Setting" interface. Once selected, press the LEVEL+ or
LEVEL- buttons to switch the level of the light sensitivity between "0/1/2/3/4/5/OFF". "OFF"
means the function will be disabled. Level 1 is the weakest light sensitivity and level 5 is the
strongest light sensitivity. After selecting your preferred AL Sensitivity setting, press the MENU
button again to save the setting and exit back to the "Display Setting" interface.
(11) "Factory Setting"- restore factory settings
Select "Factory Setting" in the "Display Setting" interface. Once selected, press the LEVEL+
or LEVEL- buttons to select "YES" / "NO". Select "YES" press the MENU button. When the
display shows "OK", it means it has successfully restored the factory settings. After
performing this action, press the MENU button again to save the setting and exit back to the
"Display Setting" interface.
(12) "Password"- boot password setting
Select "Password" in the "Display Setting" interface. Once selected, press the LEVEL+ or
LEVEL- buttons to select "Start Password" and then press the MENU button again. Next,
press the LEVEL+ or LEVEL- buttons to switch between "OFF" / "ON". Below is the specific
method for setting and changing the start-up password.
Starting password:
Enter the "Start Password" option and select "ON". Press the MENU button, and then the
display will show input password. Next, press the LEVEL+ or LEVEL- buttons to switch the
numbers "0-9", and then press the MENU button to confirm the inputted number. Repeat this
process for all 4 digits. Next, the display will show Please Confirm Your Password. Repeat the
previous step to input that same password again. If the password is same as the previous
time, the system will prompt it has successfully set the password. Otherwise, you will need to
repeat from the start of the "Starting Password" procedure.
After setting the password, press the MENU button again to save the setting and exit back to
the "Display Setting" interface.
Changing password
After setting your password, the "Password" setting will have an added option of "Reset
Password". Select "Reset Password" using the LEVEL+ or LEVEL- buttons and enter using
the MENU button. This time it will prompt you to input the current password for the interface. If
Advertisement
