Table of Contents
Advertisement
Quick Links
Interface
Buttons
Operation
Power On/Off
To turn the display on press and hold the POWER button. To turn off the display again press
and hold the POWER button.
Change Assist Level
With the display powered on use the UP button to increase your assist level. Use the DOWN
button to decrease your assist level.
Headlight Operation
Press and hold the UP button to turn on the bike headlight and the display's back light. To turn
these off press and hold the UP button again.
Switching between TRIP and TOTAL Odometer
Press the POWER button to switch the display between the Trip Odometer and Total Distance
Odometer.
Bafang C961 Display Guide
Biktrix Version
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Biktrix Bafang C961
Summary of Contents for Biktrix Bafang C961
- Page 1 Bafang C961 Display Guide Biktrix Version Interface Buttons Operation Power On/Off To turn the display on press and hold the POWER button. To turn off the display again press and hold the POWER button. Change Assist Level With the display powered on use the UP button to increase your assist level. Use the DOWN button to decrease your assist level.
- Page 2 Trip Meter Reset With the power on press and hold both the POWER and DOWN buttons to reset the trip odometer. Entering Walking Mode Press and hold the DOWN button to enter walking assist mode. This will power the motor and move the bike at 6km/h for you to walk alongside the bike.
- Page 3 Back light Brightness Press the UP and DOWN buttons to change the brightness of the display’s back light. Brightness ranges from 1 being the darkest to 8 being the brightest. Press the POWER button to save your selection and advance to the next parameter. Time Press the UP and DOWN buttons to change the hour.
- Page 4 PAS Level Amount Setting Press the UP and DOWN buttons to change how many PAS levels the bike will have. This can range from 2 to 9 levels (excluding level 0 with no motor power). Press the POWER button to save changes and leave the Advanced Settings mode. Error Codes When something goes wrong with the eBike’s systems an error code will flash on the display.
- Page 5 Error Code Definition Throttle not returning to zero state Throttle abnormality Low Voltage Protection Over Voltage Protection Hall Sensor Abnormality Phase Line abnormality Controller overheat Temperature Sensor in controller abnormality Current sensor abnormality Speed sensor abnormality Communication abnormality in BMS...
Need help?
Do you have a question about the Bafang C961 and is the answer not in the manual?
Questions and answers