Advertisement
Quick Links
Functions and Display
Operation
On/Off
Hold the POWER button to turn on the display. Hold the POWER button again to turn off the
display. If the e-bike is not used for 5 consecutive minutes, the display will automatically shut
off.
Toggle Display Modes
Tap the POWER button to switch between screen modes – Display 1, Display 2 and Display 3.
When in Display 2 or Display 3 while riding, the screen will switch to Display 1 after 5 seconds.
KT-LCD5 Manual
Biktrix Version
Advertisement
Related Manuals for Biktrix KT-LCD5
Summary of Contents for Biktrix KT-LCD5
- Page 1 KT-LCD5 Manual Biktrix Version Functions and Display Operation On/Off Hold the POWER button to turn on the display. Hold the POWER button again to turn off the display. If the e-bike is not used for 5 consecutive minutes, the display will automatically shut off.
- Page 2 Changing Assist Level Press the UP or DOWN buttons to switch between assist levels 1-5. Level 1 is the lowest level of assistance, Level 5 is the highest level of assistance. Upon start-up the display will automatically return to the gear you shutdown in last time. Level 0 has no motor assistance. Turning on Headlight and Display Back light Hold the UP button to turn on the display back light and headlight.
- Page 3 Resetting Single Trip Distance (TM ) and Single Riding Time (DST) After the display has been powered on for 5 seconds, hold the UP and DOWN buttons at the same time. The TM and DST readings on the screen will flash. Tap the POWER button shortly to clear the display.
- Page 4 General Display Settings Setting Maximum Motor Speed Within 5 seconds of powering on the bike, hold the UP and DOWN buttons at the same time. MXS and Km/H (MPH if you have the display set for that) will flash. Use the UP and DOWN buttons to raise or lower the maximum motor speed where the motor will power the bike up to.
- Page 5 Change units between Km/H and MPH Hold the UP or DOWN buttons to select between Metric or Imperial units for speed and distance. After setting your preferred units short press the POWER button to re enter the Maximum Motor Speed setting or hold the POWER button to save setting values and return to Display 1.
-
Page 6: Error Codes
Error Codes When there is a problem with the display or motor the display may show an error code. Which each error code represents is tabulated below – contact Biktrix support for assistance in steps to resolve these errors. Error...