Assembly - Murray 385048x151A Operator's Manual

Assembly

All fasteners are in the parts bag. Do not discard any
parts or material until the unit is assembled.
WARNING
Before doing any assembly or maintenance to the
mower, remove the wire from the spark plug.
NOTE: In this instruction book, left and right describe
the location of a part with the operator on the seat.
Install the Front Wheels
Use a knife and cut the four sides of the container. In-
stall the front wheels (1) in the container (see Figure 1).
NOTE: Use a piece of wood about 4 feet (1.25 meters)
long to raise the front of the tractor. If a piece of wood
cannot be found, get another person to help lift the
tractor. Be careful, do not let the tractor fall.
7
(17x195)
4
(17x192)
5
(30x49)
6
2
1. Raise the front of the tractor. Set a support (block
of wood) under the tractor.
2. Make sure the valve stem (2) is to the outside of
the tractor. Slide the front wheel (1) on the spindle
(3).
3. Fasten each front wheel with washer (4), washer
(7) and cotter pin (5). Bend the ends of the cotter
pin apart to keep the front wheel on the spindle.
4. After the front wheels are installed, lift the
tractor from the support. Roll the tractor off of the
container.
5. If your tractor has hub caps (6), install the hub
caps. Make sure the washers hold the hub caps in
place.
Install the Seat
1. Carefully remove the plastic bag from the seat.
2. Align the holes in the seat hinge (2) to the holes in
the seat (1) (see Figure 2). Fasten the seat to the
seat hinge with the fasteners (4) and (5).
3. Check the operating position of the seat. If the
seat needs to be adjusted, loosen the two wing
bolts (5). Slide the seat forward or backward along
the seat adjusting holes (3).Tighten the wing bolts.
3
4
Assemble the Steering Wheel
3
1. Make sure the front wheels point forward.
2. Slide the cover (3) over the steering post (2)
1
(see Figure 3). Make sure the collar of the cover
is on top.
3. Slide the steering wheel (1) onto the steering post.
4. Attach the steering wheel to the steering post with
screw (4) and washer (6).
Figure 1
5. Some models have an optional insert (7) in the
parts bag. Attach the insert to the center of the
steering wheel.
en
1
2
5
Figure 2
7
4
6
1
3
2
Figure 3
9