GE Caf�© C2S980SEMSS Owner's Manual & Installation Instructions page 55

Problem
Oven not clean after
a clean cycle
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
"F—and a number or
letter" flash in the display
"Probe" appears in
the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
Power outage,
clock flashes
"Burning" or "oily"
odor emitting from
the vent
Strong odor
LOC appears in
the display
Possible Causes
Oven controls not properly set.
Oven was heavily soiled.
The self-clean cycle has been
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function error code.
If the function code repeats.
This is reminding you to enter
a probe temperature after
plugging in the probe.
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not pressed properly.
Power outage or surge.
This is normal in a new oven
and will disappear in time.
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
The Gas/Control Lockout feature
is activated.
What To Do
• See the Using the self-cleaning oven section.
• Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or
for a longer period of time.
• Close the oven door.
• Touch the CLEAR/OFF pad. Allow the oven to cool.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the range for 5 minutes and
then reconnect power. If the function error code
repeats, call for service.
• Enter a probe temperature.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• Be sure the surface burner controls are turned OFF.
Turn this feature off to use the range. See the
Gas/Control Lockout section.
ge.com
55