GE C2S980SEMSS Dimensions And Installation Information

C2S980SEMSS
GE Café Free-Standing Dual-Fuel Range
Dimensions and Installation Information (in inches)
You must use the rear filler strip kit shipped with
the range or the optional accessory backguard
when installing these ranges
Note: Cabinets installed adjacent to slide-in
ranges must have an adhesion spec of at least
194° temperature rating.
Optional Kits for Slide-In Gas Ranges:
(Available at additional cost)
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
For answers to your Monogram, GE Profile
®
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center
®
800.626.2000.
37-1/4"
26-1/4"*
46-3/8"
*Dimensions from wall
to front of closed door
handle is 29"
30"
37-1/4"
30" Slide-In Range
Dimensions (in inches)
26-1/4"*
46-3/8"
*Dimensions from wall
to front of closed door
handle is 29"
30" Min.
or
™
15" Min.
service,
30
4-1/2
6
5
2-1/4
Acceptable
Electrical
Outlet Area
*Wall to front of
+ _
36-1/4" 1/4
NOTE: Make
the left side and electrical conections
30" Slide-in Elec. Range
on the right side of the
cutout opening.
30" Slide-In Range
Recommended area
Dimensions (in inches)
for through-the-wall
connection of pipe
stub/shut-off valve.
This area allows
flush installation
to rear wall.
30" Slide-in Elec. Range
Aug. 8, 2003 -km
+ _
36-1/4" 1/4
30" Min.
Recommended area for
through-the-floor connection 6
15" Min.
of pipe stub/shut-off valve.
30
4-1/2
6
5
NOTE: Make
the left side and electrical conections
2-1/4
Acceptable
on the right side of the
Electrical
cutout opening.
Maintain
Outlet Area
at least 6"
from nearest
combustible
*Wall to front of
6 surface.
closed door handle
28-1/4*
on model JSP34.
28" on models
45-1/8
31-1/2
JSP26/JSS26/16.
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
Note: Range may be placed with 0" clearance (flush) at the back wall and side walls
below countertop if the range side trims above the countertop extend beyond the cabinet
This area allows
fronts at least 1/4". (Self-clean models only.) Maintain at least 6" distance from nearest
flush installation
36
combustible surface.
to rear wall.
gas connections on
30
Aug. 8, 2003 -km
3
4
3 8
3
9
2-1/4
7-1/2 Maintain 2
at least 6"
from nearest
Product is shipped with 4-prong
combustible
plug. Recommended outlet is
surface.
a NEMA 14-50R receptacle.
31-1/2
Counter Cutout Dimensions (in inches)
If you are NOT using the
Filler strip or Backguard:
gas connections on
36
30
23-3/16
3
4
3 8
30
3
30
9
All GE ranges are equipped with
an Anti-Tip device. The installation
If you are using the
of this device is an important,
required step in the installation
Filler strip or Backguard:
of the range.
2-1/4
Specification Revised 12/07
25
7-1/2 2
Recommended acceptable
electrical outlet area. Orient
the electrical receptacle so the
length is parallel to the floor.
Wall-Mounted
If you are NOT using the
Filler strip or Backguard:
23-3/16
30
If you are using the
Filler strip or Backguard:
Recommended acceptable
electrical outlet area. Orient 25
the electrical receptacle so the
length is parallel to the floor.
30
Wall-Mounted
221218