Dip Switches - HID Mercury LP1502 Installations And Specifications

Powering
Trusted Identities

2.2 DIP switches

The four switches on S1 DIP switch configure the operating mode of the LP1502 processor. DIP switches are
read on power-up except where noted. Pressing reset switch S2 causes the LP1502 to reboot.
1 2 3
OFF OFF OFF OFF
ON X OFF OFF
OFF ON OFF OFF
ON ON OFF OFF
ON ON OFF OFF
X X X
Note: All other switch settings for unassigned and are reserved for future use. X = don't care.
Caution: In the factory or OEM default modes, downloaded configuration/database is not saved to flash
memory.
2.3 Factory default communication parameters
Interface 1 (NIC1)
Network: static IP address
Subnet mask
Default gateway
DNS server
Primary host port
Alternate host port
PLT-05244, A.3
4 Definitions
Normal operating mode.
After initialization, enable default User Name (admin) and Password (password). The
switch is read on the fly, a re-boot is not required. See
information.
Use factory default communication parameters.
Use OEM default communication parameters. Contact system manufacture for details.
See Bulk erase configuration
Bulk Erase prompt mode at power up. See
ON Makes the LP1502 report and function like an EP1502. To be used in situations where the
host software has not been updated to support the LP series product line.
192.168.0.251
255.255.0.0
192.168.0.1
192.168.0.1
IP server, Data security: TLS if Available, port 3001, communication address: 0
Disabled
memory.
Bulk erase configuration
9
HID Mercury™ LP1502 Controller
Installation and Specifications
IT security for additional
memory.
June 2021