Panasonic SA-AK58 Service Manual page 54

No. Error
1 MODE SW detection error
2 REC INH SW detection
error
3 HALF SW detection error
4 Reel Pulse detection error
5 TPS abnormal
11.2. Error Detection for CD/Changer block
No. Error
1 REST SW detection error
2 CD tray opens
automatically
3 Does not startup when /
"TUNE/TIME ADJ^"
button is / pressed
4 Transmission error
between CD / servo LSI
and micon
5 Startup fails even when
you insert CD or the
selected disc tray does
not open
6 Cannot insert CD
7 Cannot eject CD
8 CD Tray closes
11.3. Error Detection for Cassette Mechanism block
No. Error
1 POWER AMP output
abnormal
Error
Display
H01 Faulty operation of cassette mechanism. / Faulty contact
or short-circuit of mechanism mode switch (S951, S971)
H02 Recording not possible. / Faulty contact or short-circuit
REC INH switch (S974, S975)
H03 Playback can not perform. / Faulty contact or short-circuit
of HALF switch (S952, S972)
F01 The tape advances slightly and then stops. / Faulty reel
pulse, faulty hole detect IC (IC951, IC971)
F02 Cassette deck will not perform TPS function. / Faulty
playback EQ/recording amplifier IC (IC1101)
Error
Display
F15 CD dose not function. / This error occurs when the Optical
Pick Up REST SW (S701) is not detected within the
specified time (about 8 seconds)
F16 CLAMP switch (S4) NG (Check & Replace)
F17 BOTTOM switch (S5) NG (Check & Replace)
F26 CD does not function. / This error occurs when the
POWER is ON for the CD block and an error is detected
after the transmission has started.
F27 Tray 1 detect switch or Tray 2 detect switch NG (Check
Replace)
F28 Tray 1 detect switch NG (Check & Replace)
F29 Check if Disc is stuck. Tray 2 detect switch NG (Confirm
Replace)
H15 CD disc tray detect switch NG (S3) (Check & Replace)
Error
Display
F61 When POWER is switch on, power become off
automatically. / During normal operation, if DC DET
become L, PCNT shall become L and the error display on
the left shall be displayed (IC500)
54
Problem Condition
Problem Condition
Problem Condition