Ducati Diavel 1260 Owner's Manual page 323

Reposition conveyor (B) and right cowling (A), then
fasten them as follows:
start the side screw (1) securing it to the
●
electrical components compartment;
start the screws (2) for lower securing to the
●
central cowling;
start screw (3) securing central cowling to right
●
cowling;
start the front retaining screw (4).
●
Tighten screws (1), (2) and (3) to a torque of 4 Nm
±10%.
Tighten screw (4) to a torque of 4 Nm ±10%.
Fit quick-release fastener (C).
Attention
The battery gives off explosive gases; never
cause sparks or allow naked flames and cigarettes
near the battery. When charging the battery, ensure
that the working area is properly ventilated.
Charge the battery in a ventilated room.
Connect the battery charger leads to the battery
terminals: the red one to the positive terminal (+),
the black one to the negative terminal (-).
Ducati disclaims any liability deriving from the use of
non-original Ducati chargers or maintainers. It is
322
B
A A
1
C
B
2
2 3
Fig 236
1
4
A 3
Fig 237