Solid-State Drive Daughter Board; Removing The Daughter Board - Dell OptiPlex 7090 Ultra Service Manual

Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the daughter board and slide the M.2 2280 solid-state
drive at an angle into the slot.
2. Replace the (M2x3.5) screw to secure the M.2 2280 solid-state drive to the chassis.
3. Turn the solid-state drive cover and align the tabs on the solid-state cover with the slots on the chassis.
4. Align the screw hole on the solid-state drive cover with the screw hole on the chassis.
5. Replace the M2x3 screw to secure the solid-state drive cover to the chassis.
Next steps
1. Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall
mount.
2. Follow the procedure in

Solid-state drive daughter board

For systems with solid-state drive in the hard drive module will not support hard drive.

Removing the daughter board

Prerequisites
1. Follow the procedure in
2. Remove the device from
mount.
3. Remove the solid-state drive in the hard drive bay:
● M.2 2230 solid-state drive
●
M.2 2280 solid-state drive
About this task
The figure indicates the location of the daughter board and provides a visual representation of the removal procedure.
102 Removing and installing components
after working on your device.
before working inside your
fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall
or
device.