Icomfort® Mobile Setup Application; Operating System Requirements; Commissioning - Lennox iComfort S30 Smart Thermostat Operating, Troubleshooting And Technical Cheat Sheet

®
8. IComfort Mobile Setup Application

8.1. Operating System Requirements

Dealer commissioning application (iComfort
Android 4.1 and higher (Google Play).

8.2. Commissioning

To commission a system using the iComfort
NOTE - It is recommend that when using the iComfort
the HD Display from the Mag-Mount before starting. Once commissioning is completed, reattached the HD Display to
the Mag-Mount.
A. Download and install the iComfort
B. Go to the Smart Hub and press the center Lennox button once.
C. The center ring LED will start blinking green for two minutes. During that time the Smart Hub will broadcast its
Wi-Fi identifier (SSID).
D. Go to your mobile device's Wi-Fi connection tool and locate the Smart Hub Wi-Fi broadcast identifier. The identifi­
er (SSID) is Direct E300-5200 for example.
NOTE - Refer to your mobile device's owners manual on how to use your Wi-Fi Connection tool.
E. To connect to the Smart Hub use the last eight digits of the Smart Hub SSID as the password (example
E3005200).
F. Once connected to the mobile device the Smart Hub center ring LED turns solid green.
G. Start the iComfort Mobile Setup Application and make sure you connect to the correct Smart hub by checking
the serial number
NOTE - The serial number check is only needed if multiple Smart Hubs are shown. For example if you have three
systems and have completed commissioning of two and while on third unit, the other two Smart hubs connection
data is still listed in the iComfort Mobile Setup Application. If you chose the wrong one it will not connect because it
would have already stopped broadcasting its connection signal.
H. Press the remote in tab on the iComfort
missioning screen.
NOTE - If the system has not been commissioned it will go to commissioning screen. If the system has already
been commissioned it will go to dealer control center.
I. Once the commissioning is completed, exit the iComfort
J. Go to the mobile device's Wi-Fi tool and manually disconnect from the Smart Hub. Or if there is no activity after
three minutes the application will automatically disconnect from the Smart Hub.
K. Once disconnected the Smart Hub LED will return to a solid blue.
®
Mobile Setup) is available for both IOS 6.0 and higher (App Store) and
®
Mobile Setup Application perform the following:
®
Mobile Setup application to commission the system, remove
®
Mobile Setup Application.
®
Mobile Setup Application home screen. This will take you to the com­
®
- 16 -
Mobile Setup Application.