Table of Contents
Advertisement
9.2.5
Operating alarm clock / snooze function
Fig. 23:
Alarm call function
A beep is available for the alarm or playing of the radio.
The active alarm call function is shown in the display [1].
The alarm signal is shown in the display when the alarm clock starts [2]. The beep or the radio
gets gradually louder.
The alarm can be interrupted for 5 minutes by pressing any button (snooze function).
The alarm times, alarm profiles, etc. are set in the configuration menu of the device.
Alarm profiles, see chapter 9.3.5 "Menu "Alarm clock" - "Alarm profiles"" on page 55.
■
Alarm times, see chapter 9.3.6 "Menu "Alarm clock" "Alarm times"" on page 57.
■
Signal tones, see chapter 9.3.8 "Menu "Alarm clock" – "Specifying "Signal tones"" on page
■
60.
Switching the alarm clock on and off is carried out in the configuration menu of the device, see
chapter 9.3.4 "Menu "Alarm clock" - "Alarm clock"" on page 54.
The maximum volume of the signal tone can be reduced, see chapter 9.3.25 "Menu "Settings -
"Maximum volume"" on page 79.
Notice
The alarm times must be entered before the alarm clock is turned on for the first
time.
–
–
Switching the alarm clock on or off
The alarm clock is switched on or off in the configuration menu of the device, see chapter 9.3.4
"Menu "Alarm clock" - "Alarm clock"" on page 54.
–
This prevents the alarm function from being inadvertently switched off via the button during
standard operation.
Interrupting the alarm clock (snooze function)
Start the snooze function by pressing any button of the device.
–
The snooze function can only be started during the signal tone.
Behaviour of the alarm call function and the snooze function
Product manual 2CKA001473B5281
Only then can the alarm clock be switched on.
Only then can the alarm days be deactivated.
Operation
│34
Advertisement
Table of Contents
