Heinner HWM-VF2610SD++ Instruction Manual page 39

www.heinner.com
FAULT
Unsatisfactory washing
result.
Unsatisfactory
washing result.
As soon as the ma-
chine is loaded with
water, water dis-
charges.
No water appears in
the drum during
washing.
Laundries have
detergent residues on
them.
Grey spots appear on
the laundries.
Spinning operation is not
performed or runs late.
POSSIBLE CAUSE
The contamination degree of your
laundries does not match the
programme you have chosen.
Amount of detergent used
insufficient.
Laundries in excess of
maximum capacity put in your
machine.
Water being hard.
( Contaminated, lime water etc.)
Laundries distributed in your
machine non- homogenously.
The end of water discharging
hose is too low for the
machine.
No fault. Water is in the
unseen part of the drum.
Non-dissolving particles of
some detergents may stick to
your laundries as white spots.
The reason for such spots may
be oil, cream or ointment.
No fault. Unbalanced load
control system has been
activated.
6Kg, 220-240V~50Hz, 1000rpm
TROUBLE- SHOOTING
Select the programme appropriate for
the contamination degree of your
laundries. (See programme table)
Adjust the amount of detergent based on
the amount and contamination degree of
your laundries.
Load your machine with laundries, amount
of which will not exceed maximum laundry
capacity.
Adjust the amount of detergent based on
the instruction of detergent manufacturer.
Spread your laundries in the ma-
chine properly and homogeneously.
Set the water discharging hose on
appropriate height.
Perform an Extra rinse by setting your
machine to "Rinsing" programme, or
clean the spots using a brush after your
laundries dry.
Apply the maximum amount of detergent
instructed by the detergent manufacturer
in the next washing operation.
Unbalanced load control system will try to
spread your laundries homogenously.
Spinning operation will begin after your
laundry is spread. Place the laundry in the
machine in a balanced fashion the next
time.
38