Unpacking The Speakers - audium Comp 3.2 Drive User Manual

Terminology
Instructions only for the Active Variant will be red Font, the only for the Drive Variant
apply in green letters (arrows / headings / text).

Unpacking the speakers

The AUDIUM speakers are delivered in separate cartons. Alter opening them, remove the
polyfoam protection elements and the textile bag. Do not dispose the packaging - you can
carry the speakers in a save way only when using the original packaging.
Spikes:
AUDIUM floor speakers radiate sound best when the front battle is inclined for a
fewdegrees. Therefor screw the front spikes for 5mm, the rear spikes totally into the
designated winding-drills. Take care that the speaker has a steady position.
Finally, tighten the spikes with the appropriate screw nuts.
Further information on the installation below in the chapter "Installation".
Note: To protect wooden floors, we recommend the use of washers, which you can get
from your dealer. Alternatively, you can also use any metal discs for bridging.
Dust-Caps:
The loudspeakers are equipped with dust-caps per default. These are simply attached
to the speaker front and can be removed with low force through pulling them oft, it you
desire.
Even though these dust-caps have been designed according to acoustic aspects, the best
sound performance can be achieved when they are removed from the loudspeakers.
Plugs in the bass reflex tube:
The bass reflex tubes are sealed with a semi-permeable foam
stopper. DO NOT remove this to change the bass response.
The tuning of the speakers is chosen so that you achieve the
maximum tonal performance WITH these plugs. If you want to
boost bass, you can do so by using the Bass setting in the
Speaker Setup.
- 5 -