Operation - audium Comp 3.2 Drive User Manual

Operation:

The display shows the current status, settings and the setup menu.
Use the rotary knob to adjust the settings on the speaker: Turn clockwise or anticlockwise
to navigate through the menu / change values. You can also use it to lock or mute the
speaker (see below "Mute and Lock of the loudspeakers").
During normal operation, the display shows the following display (here from a Comp8
.2
Active):
Muting and locking the speaker:
Mute the speaker:
If you press the rotary knob briefly while the status is displayed, the loudspeaker is muted.
So you can simply stop the playback to plug or unplug the RCA cable without causing loud
hum or drone noises.
Press again to unmute the speakers. This also happens automatically after 10 seconds
(this value can be changed in the Setting menu).
Locking the speaker:
To prevent unwanted changes to the parameters, you can lock the speaker. Press and hold
the knob while the display shows the speaker status. The Operation is then disabled (and
thus prevent the creation of settings by your children!). To unlock, press and hold the knob
again.
If the speaker is disconnected from the mains, the lock is released.
Muted Unmuted Locked Unlocked
Automatic switching on and off.
The speakers have integrated music signal detection. If no music is played back,
the Speaker goes to standby after 15 minutes (this value can be changed in the Settings
menu). If music signal is detected, then the Speaker switch back on automatically.
Note:
If you are the Disconnecting speakers from the mains you have nothing to note. Restarting
/ plugging brings your speakers back to their last state. All parameters (except the lock -
see above) are stored in a long-term memory that does not lose its contents.
- 10 -