Ce-Sign, Emc Regulations - Volvo L20B Owner's Manual

Presentation

CE-Sign, EMC Regulations

7
CE-Sign,
EMC Regulations
CE-Sign
(Declaration of Conformity)
(Applies only for machines, which are to be sold within the
European Community)
"The machine was awarded with a CE-Sign".
This means that the machine fulfils the appropriate "General
Health and Safety Requirements" of the so-called EC machine reg-
M300128A
ulations.
As a proof for the fulfilment of the above mentioned requirements
the machine is delivered with a EC Declaration of Conformity. If
any conversions are made which will impair the safety of the
machine, the person modifying the machine is fully responsible for
the resulting effects.
If the machine is used for purposes other than those mentioned in
these operating instructions, the safety of the machine must be
assured at any time. Whoever uses the machine for such meas-
ures is fully responsible. In certain cases it may be necessary to
obtain a new CE-sign and to issue a new declaration of conformity.
We will only assume reliability for machines which are oper-
ated with the attachments, equipment and spare parts speci-
fied by us.
The attachments (optional equipment) manufactured by us are
adapted integral parts of the machine. The CE-sign therefore cov-
ers also our attachments. We do not assume liability for attach-
ments made by other manufacturers.
Materials which have an effect on noise such as noise insulating,
noise reducing or noise absorbing materials must not be changed
or removed. It is also prohibited to cut holes into the cabin or the
engine compartment, because this would have a negative effect
on the noise level.
EMC regulations of the EC
Under certain conditions the electronic equipment may have an
interfering effect on other electronic equipment, or other electronic
equipment may interfere with the electronic equipment on the
machine, which may impair the safety. The EMC regulations of the
EC concerning the "electromagnetic conformity" contain a general
description of the requirements, which may be appropriate for the
safety of a machine, the limits of which are specified in interna-
tional standards. Machines or apparatuses which meet these
demands are awarded with the CE-sign. Our machines have been
especially tested with respect to electro-magnetic interferences.
Both the CE-sign and the declaration of conformity refer to the
EMC regulations. If another piece of electronic equipment is to be
fitted to the machine it must have the CE-sign and the machine
must be checked with respect to electro-magnetic interferences.