Starting The Engine - Volvo L20B Owner's Manual

Table of Contents

Advertisement

Travel
42

Starting the engine

5
Starting the engine
0000 00 h
7
– Insert the ignition key into the ignition switch and turn it to posi-
tion I. Control lights (5) for charging of battery and (7) for engine
oil pressure must light up.
– When the engine is cold the control light (12) "preheating" will
light up (temperature dependent).
– Kick the drive pedal down to 1/4 load.
– Once the control light (12) "preheating" has gone out turn the
ignition key to position II and "start". As soon as the engine
starts to run by itself release the ignition key (returns to position
I). Do not start for longer than 25 seconds without interruption.
– If the engine does not start turn the ignition key back to position
"0" and repeat the starting procedure. Once the engine is run-
ning the above mentioned control lights must go out.
Note:
Avoid excessive loading of the wheel loader immediately after
starting. Observe the warm-up instructions.
12
M200053A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents